Home › Power Source / Network › 2WW BATTERY / CHARGING › CHARGING SYSTEM › from 2015.10
NM3090E _57 Power Source / Network _047564 2WW BATTERY / CHARGING _0224816 CHARGING SYSTEM CO CONTROL F

2WW BATTERY / CHARGING  CHARGING SYSTEM  CONTROL  CHARGING CONTROL  


SYSTEM CONTROL


a.

This system lowers the generated voltage when the vehicle is not decelerating, and raises the generated voltage when the vehicle is decelerating. This reduces the load on the engine as a result of electric generation of the generator, thus contributing to improved fuel economy. When idling or driving at a constant speed, this system regulates the generated voltage in order to place the current integrated value close to the target value.


b.

This control consists of the generator control ECU assembly with a built-in battery current sensor, battery temperature sensor, generator assembly, ECM, various sensors and switches.


c.

The ECM detects the driving conditions based on signals from various sensors and switches. The generator control ECU assembly detects the charging condition based on signals from the generator assembly, battery current sensor and battery temperature sensor. The ECM determines the vehicle driving conditions, and based on this information, the generator control ECU assembly sends a voltage request signal to the generator assembly.


d.

The generator control ECU assembly stops charging control and the generator switches to the constant voltage generation mode under the following conditions:

i.

Low battery capacity


ii.

Low or high battery temperature


iii.

Wipers operating or blower motor operating over high load or taillight relay ON


iv.

Battery current sensor or battery temperature sensor malfunction


v.

Engine started


vi.

Communication failure (Local communication between generator control ECU assembly and ECM)


vii.

Generator assembly malfunction


viii.

Battery charged for approximately 2.5 to 4 hours


ix.

Accumulated driving time becomes approximately 20 hours