SYSTEM CONTROL
The power window control system has the following functions:
| Function | Outline |
|---|---|
| Manual Up-and-down | ·
This function causes the window to open or close while the power window regulator master switch assembly is being pulled halfway up or pushed halfway down. The window stops as soon as the switch is released.*1 ·
This function causes the window to open or close while the power window regulator master switch assembly is being pulled up or pushed halfway down. The window stops as soon as the switch is released.*2 ·
This function causes the window to open or close while the power window regulator master switch assembly or power window regulator switch assembly is being pulled up or pushed down. The window stops as soon as the switch is released.*3 |
| One-touch Auto Up-and-down (Driver Door)*4 | The one-touch auto up-and-down function enables the window to be fully opened or closed by firmly operating the power window regulator master switch assembly. |
| One-touch Auto Down (Driver Door)*5 | The one-touch auto down function enables the window to be fully opened by firmly operating the power window regulator master switch assembly. |
| Jam Protection (Driver Door)*4 | The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in the window during one-touch auto-up operation or manual up operation. |
| Catch Protection (Driver Door)*4 | The catch protection function automatically stops the power window if a foreign object gets caught in the window during a down operation. |
| Remote Control | The up-and-down operations of the front passenger door window and the rear door windows can be controlled by operating the power window regulator master switch assembly. |
| Window Lock | Operation of the 3 passenger windows is disabled when the window lock switch is pressed. |
| Key Off Operation | ·
This function makes it possible to operate the power windows for approx. 43 seconds after the ignition switch is turned to ACC or off, when the front doors are not opened. ·
When the window lock switch is off, the windows can be operated using any of the power window regulator switch assemblies. When the window lock switch is on, only the power window regulator master switch assembly can be used to operate the windows. |
*1: Door with one-touch auto up-and-down function only
*2: Door with one-touch auto down function only
*3: Door without one-touch auto up-and-down function only
*4: Models with one-touch auto up-and-down function
*5: Models with one-touch auto down function
The ECU built into driver power window motor stores the initial position of its door window. The initial position is not cleared even if battery terminals, fuses or the power window motor connector is disconnected. However, after removing or reinstalling window components, or replacing the power window regulator sub-assembly or power window regulator motor, the stored initial position data must be cleared and initialization must be performed. For details, refer to the Repair Manual.
Jam Protection Function (Driver Door)
The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in the door window during one-touch auto up operation or manual up operation.
In the case of manual up operation using the power window regulator switch assembly, the power window is moved downward by approximately 30 mm (1.2 in.) or for approximately 5 seconds. In the case of up operation except for manual up operation using the power window regulator switch assembly, the power window is moved downward by approximately 145 mm (5.7 in.) or for approximately 5 seconds.
The power window ECU determines if a foreign object gets jammed according to changes in the output signal from the pulse sensor (Hall IC). Both of the following 2 judgment methods are used:
Catch Protection Function (Driver Door)
The catch protection function automatically stops the power window if a foreign object gets caught in the window during a down operation.
The power window ECU determines if a foreign object gets caught according to changes in the output signal from the pulse sensor (Hall IC). The judgment method is as follows:
FAIL-SAFE
If a pulse sensor (Hall IC) in the power window regulator motor assembly malfunctions, the power window control system enters fail-safe mode. For details, refer to the Repair Manual.