Home › Engine / Hybrid System › 1AD-FTV EMISSION CONTROL › EXHAUST FUEL ADDITION INJECTOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008371 1AD-FTV EMISSION CONTROL _0046706 EXHAUST FUEL ADDITION INJECTOR G

1AD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR  INSPECTION  


PROCEDURE

Hide 23710B 1.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

a.
A201818
0.094,0.052 0.406,0.208 0.313,0.156 10 *a 0.531,0.604 0.688,0.802 0.156,0.198 10 2 0.729,0.604 0.885,0.802 0.156,0.198 10 1
*a Component without harness connected
(Exhaust Fuel Addition Injector Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 7.1 to 7.9 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the exhaust fuel addition injector assembly.


If the result is not as specified, replace the exhaust fuel addition injector assembly.