Home › Engine / Hybrid System › 1AD-FTV EMISSION CONTROL › DIFFERENTIAL PRESSURE SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008371 1AD-FTV EMISSION CONTROL _0046707 DIFFERENTIAL PRESSURE SENSOR G

1AD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89480A 1.CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / DPF Differential Pressure.

Powertrain > Engine > Data List
Tester Display
DPF Differential Pressure
50003 61 238

e.

Slide the clamp and disconnect the vacuum transmitting hose assembly from the differential pressure sensor assembly.


f.
A206306
0.833,2.583 1,2.583 1,2.583 1.24,3.115 true 1.563,4.167 1.875,4.323 0.313,0.156 10 *a 0.542,2.49 1,2.688 0.458,0.198 10 SST
*a Pressure


Using SST, apply pressure to the differential pressure sensor assembly.

SST
09992-00242  


g.

Check the pressure value of the differential pressure sensor assembly.

Standard pressure:

Approximately the same pressure as the applied pressure is indicated on the GTS.


NOTICE:

Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).


If the result is not as specified, check the differential pressure sensor circuit.

Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>P2454


h.

Connect the vacuum transmitting hose assembly to the differential pressure sensor assembly, and slide the clamp to secure the hose.