Home › Engine / Hybrid System › 2AD-FTV ENGINE MECHANICAL › DRIVE BELT
RM3090E _51 Engine / Hybrid System _008372 2AD-FTV ENGINE MECHANICAL _0046713 DRIVE BELT A

2AD-FTV ENGINE MECHANICAL  DRIVE BELT  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443 2.REMOVE REAR ENGINE UNDER COVER RH

a.
A299168

Remove the 2 clips and rear engine under cover RH.


Hide 51217A 3.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

a.
A295895

Remove the 4 bolts and front suspension member reinforcement RH.


Hide 16361A 4.REMOVE FAN AND GENERATOR V BELT

a.
A214114N01
0.643,2.576 0.952,2.764 0.309,0.188 10 SST 1.941,2.235 1.117,2.654 1.117,2.654 1.005,2.654 false

Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the fan and generator V belt.

SST
09216-42010  

CAUTION:
·

Be careful as the wrench only fits loosely on the V-ribbed belt tensioner assembly tool set point. The wrench may come off the set point and cause injuries.

·

Be careful that your hands do not become jammed between parts such as the fan and generator V belt, pulleys, etc.



NOTICE:

Make sure SST is installed as shown in the illustration. If not, SST and/or the fan and generator V belt may not be able to be removed.