Home › Engine / Hybrid System › 2AD-FTV ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL
RM3090E _51 Engine / Hybrid System _008372 2AD-FTV ENGINE MECHANICAL _0046717 FRONT CRANKSHAFT OIL SEAL A

2AD-FTV ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL FRONT CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new front crankshaft oil seal.

NOTICE:

Keep the lip free of foreign objects.



b.
A202326
2.135,2.229 2.563,1.969 2.563,1.969 2.646,1.969 false 2.677,1.865 3,2.031 0.323,0.167 10 SST

Using SST and a hammer, tap in the front crankshaft oil seal as shown in the illustration.

SST
09223-50010  

Standard depth:

0 to 0.6 mm (0 to 0.0236 in.)


NOTICE:
·

Do not tap the front crankshaft oil seal at an angle.

·

Wipe off any excess grease from the crankshaft.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.

Align the keyway of the crankshaft pulley with the key located on the crankshaft, and then slide the crankshaft pulley into place to install it.


b.
A273396
1.417,1.958 0.885,0.906 0.885,0.906 0.667,0.906 true 2.438,0.677 1.74,0.677 true 2.292,2.448 2.573,2.031 2.573,2.031 2.708,2.031 true 0.344,0.802 0.802,1 0.458,0.198 10 false SST 1.417,0.573 1.875,0.771 0.458,0.198 10 false SST 2.76,1.948 3.219,2.146 0.458,0.198 10 false SST

Using SST, install a new pulley bolt.

SST
09213-58014  (91551-80840)
09330-00021  

Torque:
300 N*m (3059 kgf*cm, 221 ft.*lbf)


Hide 16361A 3.INSTALL FAN AND GENERATOR V BELT