Home › Engine / Hybrid System › 2AD-FTV ENGINE MECHANICAL › CYLINDER BLOCK
RM3090E _51 Engine / Hybrid System _008372 2AD-FTV ENGINE MECHANICAL _0046720 CYLINDER BLOCK A

2AD-FTV ENGINE MECHANICAL  CYLINDER BLOCK  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE CYLINDER BLOCK STRAIGHT PIN

HINT:

It is not necessary to remove the cylinder block straight pin unless it is being replaced


a.

Remove the cylinder block straight pin.


b.

Using a plastic-faced hammer, tap in a new cylinder block straight pin to the cylinder block sub-assembly.

Standard Protrusion:
Item Specified Condition
Pin A 11 mm (0.433 in.)
Pin B 7.0 mm (0.726 in.)
Pin C 18 mm (0.709 in.)
Pin D 7.5 mm (0.725 in.)
Pin E 7.5 mm (0.725 in.)


A293314
0.146,0.115 0.458,0.271 0.313,0.156 10 *a 3.906,0.104 4.219,0.26 0.313,0.156 10 *b 0.125,2.021 0.438,2.177 0.313,0.156 10 *c 3.927,2.344 4.24,2.5 0.313,0.156 10 *d 0.156,3.958 0.469,4.115 0.313,0.156 10 *e 0.438,1.75 0.594,1.948 0.156,0.198 10 A 2.271,1.115 2.427,1.313 0.156,0.198 10 A 4.24,0.938 4.417,1.146 0.177,0.208 10 B 6,0.594 6.177,0.802 0.177,0.208 10 B 4.521,1.813 4.698,2.021 0.177,0.208 10 C 5.177,2.646 5.354,2.854 0.177,0.208 10 B 5.688,2.594 5.865,2.802 0.177,0.208 10 B 2.76,2.385 2.917,2.583 0.156,0.198 10 D 0.552,2.365 0.708,2.563 0.156,0.198 10 D 2.74,4.323 2.99,4.521 0.25,0.198 10 E 0.469,4.427 0.719,4.625 0.25,0.198 10 E 0.833,6.219 0.99,6.417 0.156,0.198 10 A 2.167,6.198 2.344,6.406 0.177,0.208 10 B 3.427,6.188 3.604,6.396 0.177,0.208 10 C 4.927,6.198 5.083,6.396 0.156,0.198 10 D 6.042,6.208 6.292,6.406 0.25,0.198 10 E
*a Rear Side *b Front Side
*c Upper Side *d Crankshaft Bearing Cap Exhaust Side
*e Lower Side - -



Hide 2.REPLACE CYLINDER BLOCK RING PIN

HINT:

It is not necessary to remove the cylinder block straight pin unless it is being replaced


a.
A206566

Using a plastic-faced hammer, tap in new cylinder block ring pins to the crankshaft bearing cap.

Standard protrusion:

6.5 mm (0.256 in.)