Home › Engine / Hybrid System › 2AD-FTV COOLING › RADIATOR
RM3090E _51 Engine / Hybrid System _008373 2AD-FTV COOLING _0046727 RADIATOR G

2AD-FTV COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16475A 1.INSPECT RESERVOIR CAP

a.

Measure the valve opening pressure.

i.
A215769C07
0.906,1.521 1.208,1.521 false 2.01,1.281 2.313,1.281 true 0.74,1.448 1.052,1.604 0.313,0.156 10 *1 2.344,1.198 2.656,1.354 0.313,0.156 10 *2
*1 O-Ring
*2 Rubber Packing


If there are water stains or foreign matter on O-ring, clean it with water and finger scouring.


ii.

Check that O-ring is not deformed, cracked or swollen.


iii.

Apply engine coolant to O-ring and rubber packing before using a radiator cap tester.


iv.
A110393C05
0.385,1.156 0.615,0.125 0.615,0.125 0.688,0.125 false 1.469,1.042 1.573,0.5 1.573,0.5 1.656,0.5 false 0.719,0.052 1.031,0.208 0.313,0.156 10 *1 1.677,0.417 1.99,0.573 0.313,0.156 10 *2 0.583,1.698 0.896,1.854 0.313,0.156 10 *a
*1 Reservoir Cap
*2 Radiator Cap Tester
*a 30° or more


Pump the cap tester several times and check the maximum pressure*.

Pump speed:

1 pump per second


HINT:
·

*: Even if the cap cannot maintain the maximum pressure, it does not necessarily indicate a defect.

·

When using the cap tester, tilt it 30° or more.



Standard Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93 to 123 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value
(after using cap)
79 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap.



Hide 16400 2.INSPECT FINS FOR BLOCKAGE

A112201

a.

Check that the radiator assembly, condenser assembly and intercooler assembly are not blocked with leaves dirt or insects. Clean the hose connections.

If the fins are blocked, wash them with water or a steam cleaner.

NOTICE:
·

If the distance between the steam cleaner and core is too close, the fins may be damaged.

·

When cleaning the intercooler assembly, make sure no water enters its interior.

·

Keep the following injection distance.

Standard Injection Distance:
Injection Pressure Specified Condition
2942 to 4903 kPa
(30 to 50 kgf/cm2, 427 to 711 psi)
300 mm (11.811 in.)
4903 to 7845 kPa
(50 to 80 kgf/cm2, 711 to 1138 psi)
500 mm (19.685 in.)


·

If the fins are bent, straighten them with a screwdriver or pliers.

·

Never apply water directly to the electronic components.




b.

Dry the fins with compressed air.