Home › Engine / Hybrid System › 1AD-FTV INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008376 1AD-FTV INTAKE / EXHAUST _0046750 EXHAUST MANIFOLD W/ TURBOCHARGER G

1AD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER  INSPECTION  


PROCEDURE

Hide 17201 1.VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

a.

Check for deformation and cracks in the turbine wheel on the exhaust side.

A263946
0.604,1.667 2.021,1.667 true 2.25,1.677 2.667,0.167 2.667,0.167 2.833,0.167 true 0.438,1.563 0.75,1.719 0.313,0.156 10 false *1 2.854,0.083 3.01,0.281 0.156,0.198 10 false A
*1 Turbine Wheel - -


If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.

HINT:

The cut part indicated in the illustration at A is normal and does not indicate that the turbine wheel is damaged.



Hide 17201 2.CHECK TURBINE SHAFT ROTATION

a.
A263947

Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.

If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.

HINT:

Due to the viscosity of the oil, it may take a little effort to rotate the turbine wheel. This is not a problem.



b.
A263948

Move the turbine wheel as shown in the illustration and check that there is no looseness in the shaft and that the turbine wheel does not contact the housing.

If there is any contact with the housing or obvious looseness in the shaft, replace the turbocharger sub-assembly.

HINT:

A clearance on the order of 100 μm exists between the turbine shaft and bearings. If it is difficult to judge the looseness of the turbine shaft, perform the same inspection on another vehicle which has the same turbocharger sub-assembly and compare the clearance.