Home › Engine / Hybrid System › 1AD-FTV LUBRICATION › OIL PRESSURE SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008379 1AD-FTV LUBRICATION _0046758 OIL PRESSURE SENSOR A

1AD-FTV LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.

Remove the adhesive from the threads of the oil pressure sender gauge assembly and the bolt hole of the No. 1 oil cooler bracket.


b.

Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.



c.

Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.



d.

Connect the oil pressure sender gauge connector.