Home › Engine / Hybrid System › 1AD-FTV LUBRICATION › OIL PRESSURE SWITCHING VALVE › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008379 1AD-FTV LUBRICATION _0046759 OIL PRESSURE SWITCHING VALVE G

1AD-FTV LUBRICATION  OIL PRESSURE SWITCHING VALVE  INSPECTION  


PROCEDURE

Hide 15350A 1.INSPECT OIL PRESSURE SWITCHING VALVE ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 13 to 17 Ω


If the result is not as specified, replace the oil pressure switching valve assembly.


b.
A231900
1.896,0.667 2.417,1.167 2.417,1.167 2.583,1.167 true 1.542,0.677 1.115,1.167 1.115,1.167 0.948,1.167 true 0.094,0.073 0.406,0.229 0.313,0.156 10 *a 2.625,1.063 2.823,1.344 0.198,0.281 10 2 0.833,1.073 1.031,1.354 0.198,0.281 10 1
*a Component without harness connected
(Oil Pressure Switching Valve Assembly)


Connect the positive (+) lead of the battery to terminal 1 and the negative (-) lead to terminal 2 and check that the operating sound of the oil pressure switching valve assembly can be heard.

NOTICE:
·

This test must be performed within 10 seconds to prevent the coil from burning out.

·

Always turn the voltage on and off at the battery, not the oil pressure switching valve assembly.



If the result is not as specified, replace the oil pressure switching valve assembly.