Home › Engine / Hybrid System › 2AD-FTV LUBRICATION › OIL PRESSURE SWITCH
RM3090E _51 Engine / Hybrid System _008385 2AD-FTV LUBRICATION _0046780 OIL PRESSURE SWITCH G

2AD-FTV LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the engine oil pressure switch connector.


b.

Start the engine.


c.
A201810
0.792,0.854 1.417,0.333 1.417,0.333 1.583,0.333 true 0.083,0.042 0.396,0.198 0.313,0.156 10 *a 1.615,0.24 1.771,0.438 0.156,0.198 10 1
*a Component without harness connected
(Engine Oil Pressure Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Body ground Engine stopped Below 1 Ω
Engine idling 10 kΩ or higher


If the result is not as specified, replace the engine oil pressure switch assembly.


d.

Connect the engine oil pressure switch connector.