Home › Engine / Hybrid System › 2AD-FTV LUBRICATION › OIL PRESSURE SWITCH
RM3090E _51 Engine / Hybrid System _008385 2AD-FTV LUBRICATION _0046780 OIL PRESSURE SWITCH A

2AD-FTV LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Remove the adhesive from the threads of the engine oil pressure switch assembly and the bolt hole of the No. 1 oil cooler bracket.


b.

Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.



c.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.



d.

Connect the engine oil pressure switch connector.