Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ACCELERATOR PEDAL
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046797 ACCELERATOR PEDAL A

2AD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:

This accelerator pedal sensor assembly does not require lubrication.

Do not apply oil or other lubrication to the accelerator pedal sensor assembly.

If applied, the accelerator pedal sensor assembly must be replaced.


a.
A273390
0.104,0.135 0.417,0.292 0.313,0.156 10 *A 0.156,2.229 0.469,2.385 0.313,0.156 10 *B
*A for LHD
*B for RHD


Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 2 bolts and accelerator pedal sensor assembly.

NOTICE:
·

Avoid physical shocks to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.