Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046800 CRANKSHAFT POSITION SENSOR G

2AD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11401G 1.INSPECT CRANKSHAFT POSITION SENSOR

a.
A158777
1.948,1.01 2.25,0.656 2.25,0.656 2.51,0.656 false 1.469,1.01 1.167,0.656 1.167,0.656 0.938,0.656 false 0.083,0.063 0.24,0.219 0.156,0.156 10 *a 2.552,0.563 2.781,0.719 0.229,0.156 10 NE 0.594,0.563 0.875,0.719 0.281,0.156 10 NE-
*a Component without harness connected (Crankshaft Position Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (NE) - 2 (NE-) Cold 835 to 1400 Ω
Hot 1060 to 1645 Ω


NOTICE:

In the table above, the terms "Cold" and "Hot" refer to the temperature of the crankshaft position sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the crankshaft position sensor.