Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046800 CRANKSHAFT POSITION SENSOR A

2AD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 27020 1.REMOVE GENERATOR ASSEMBLY

Hide 11401G 2.REMOVE CRANKSHAFT POSITION SENSOR

a.

Disconnect the crankshaft position sensor connector.


b.
A273387

Using a clip remover, remove the clip.


c.

Remove the bolt and disconnect the crankshaft position sensor wire harness.


d.

Remove the bolt and crankshaft position sensor.