Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046801 ENGINE COOLANT TEMPERATURE SENSOR G

2AD-FTV ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422C 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.

Partially immerse the engine coolant temperature sensor in water and warm up the water.

A196021
5.948,1.104 6.188,0.688 6.188,0.688 6.313,0.688 false 4.75,0.125 5.104,0.427 0.354,0.302 10 kΩ 5.052,0.125 5.375,0.333 0.323,0.208 8 30 5.052,0.26 5.375,0.469 0.323,0.208 8 20 5.052,0.479 5.375,0.688 0.323,0.208 8 10 5.083,0.719 5.406,0.927 0.323,0.208 8 5 5.083,0.896 5.406,1.104 0.323,0.208 8 3 5.083,1.031 5.406,1.24 0.323,0.208 8 2 5.083,1.25 5.406,1.458 0.323,0.208 8 1 5.042,1.802 5.365,2.01 0.323,0.208 8 0.2 5.042,1.656 5.365,1.865 0.323,0.208 8 0.3 5.042,1.479 5.365,1.688 0.323,0.208 8 0.5 5.052,2.01 5.375,2.219 0.323,0.208 8 0.1 5.542,2.281 5.708,2.458 0.167,0.177 8 0 5.75,2.281 5.948,2.458 0.198,0.177 8 20 5.99,2.281 6.198,2.448 0.208,0.167 8 40 6.26,2.281 6.438,2.469 0.177,0.188 8 60 6.51,2.281 6.719,2.458 0.208,0.177 8 80 6.729,2.281 6.99,2.458 0.26,0.177 8 100 5.25,2.396 5.5,2.583 0.25,0.188 8 (-4) 6.49,2.594 7.094,2.792 0.604,0.198 10 °C (°F) 4.708,1 5.021,1.156 0.313,0.156 10 *1 5.896,2.615 6.208,2.771 0.313,0.156 10 *2 6.417,0.604 6.729,0.76 0.313,0.156 10 *3 1.135,0.875 1.448,1.031 0.313,0.156 10 *a 5.24,2.281 5.469,2.458 0.229,0.177 8 -20 5.469,2.396 5.719,2.594 0.25,0.198 8 (32) 5.708,2.396 5.948,2.604 0.24,0.208 8 (68) 5.927,2.396 6.25,2.563 0.323,0.167 8 (104) 6.208,2.396 6.521,2.583 0.313,0.188 8 (140) 6.479,2.396 6.823,2.583 0.344,0.188 8 (176) 6.75,2.396 7.063,2.573 0.313,0.177 8 (212)
*1 Resistance *2 Temperature
*3 Acceptable Range - -
*a Component without harness connected (Engine Coolant Temperature Sensor) - -



b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.


If the result is not as specified, replace the engine coolant temperature sensor.