Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046803 MANIFOLD ABSOLUTE PRESSURE SENSOR G

2AD-FTV ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421C 1.CHECK DIESEL TURBO PRESSURE SENSOR

a.
A162709
1.198,1.323 0.646,1.323 true 2.01,1.323 2.563,1.323 true 0.104,0.042 0.271,0.198 0.167,0.156 10 *a 0.385,1.229 0.604,1.385 0.219,0.156 10 E2 2.604,1.229 2.823,1.385 0.219,0.156 10 VC
*a Front view of wire harness connector (to Diesel Turbo Pressure Sensor)


Inspect the power source voltage.

i.

Disconnect the diesel turbo pressure sensor connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
3 (VC) - 1 (E2) Ignition Switch ON 4.75 to 5.25 V



iii.

Turn the ignition switch off.


iv.

Reconnect the diesel turbo pressure sensor connector.



b.

Check the vacuum and pressure.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / Atmosphere Pressure and MAP.

Powertrain > Engine > Data List
Tester Display
Atmosphere Pressure
MAP
50003 61 64,314

v.

Disconnect the vacuum hose from the diesel turbo pressure sensor.


vi.
A273392
2.646,1.302 2.76,0.844 2.76,0.844 2.917,0.844 false 2.99,0.76 3.396,0.969 0.406,0.208 10 SST

Using SST, apply pressure to the diesel turbo pressure sensor.

SST
09992-00242  


vii.

Using a vacuum pump, apply vacuum to the diesel turbo pressure sensor.


viii.

Read the value.

OK:
Condition Map and Atmosphere Pressure Value
No pressure applied Same as atmospheric pressure
Vacuum applied Becomes vacuum
Pressure applied Becomes pressurized


If the result is not as specified, replace the diesel turbo pressure sensor.