Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › AIR FUEL RATIO SENSOR(for DPF)
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0046804 AIR FUEL RATIO SENSOR(for DPF) A

2AD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR(for DPF)  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A273330C01
0.833,1.188 0.573,0.708 0.573,0.708 0.406,0.708 false 2.292,0.406 2.604,0.563 0.313,0.156 10 false *1 0.073,0.635 0.531,0.833 0.458,0.198 10 false SST
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with afulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

·

Make sure SST and the wrench are connected in a straight line.




b.

Install the harness clamp.


Hide 2.INSTALL FRONT EXHAUST PIPE ASSEMBLY