Home › Engine / Hybrid System › 3ZR-FAE ENGINE MECHANICAL › DRIVE BELT › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _008387 3ZR-FAE ENGINE MECHANICAL _0046810 DRIVE BELT G

3ZR-FAE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT V-RIBBED BELT

a.
A122920

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the V-ribbed belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
A141644C03
0.521,1.344 0.833,1.5 0.313,0.156 10 *a 2.354,1.344 2.667,1.5 0.313,0.156 10 *b
*a CORRECT
*b INCORRECT


Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.



c.
A150575
1.031,0.313 1.344,0.469 0.313,0.156 10 *a 1.552,1.948 1.865,2.104 0.313,0.156 10 *b
*a Deflection
*b Tension


Check the V-ribbed belt deflection and tension.

Standard Deflection:
Item Specified Condition
New belt 7.0 to 8.2 mm (0.276 to 0.323 in.)
Used belt 7.6 to 10.0 mm (0.299 to 0.394 in.)


Standard Tension:
Item Specified Condition
New belt 700 to 800 N (70 to 80 kgf, 157.4 to 179.8 lbf)
Used belt 550 to 750 N (55 to 75 kgf, 123.6 to 168.6 lbf)


HINT:
·

When inspecting the V-ribbed belt deflection, apply 98 N (10 kgf, 22.0 lbf) of tensile force to it.

·

Check the V-ribbed belt deflection at the specified point.

·

V-ribbed belt tension and deflection should be checked after 2 revolutions of engine cranking.

·

Measure the belt tension when the engine is cold.

·

When adjusting the belt, be sure to adjust it so that the tension is as close as possible to the median of the specified range.

·

When replacing the belt with a new one, be sure to perform the following after adjusting the belt: idle the engine for 5 minutes, and then adjust the belt to the specified value for a new belt after the engine has cooled.

·

When inspecting a belt which has been used for over 5 minutes, apply the used belt specifications.

·

When using a belt tension gauge, confirm its accuracy by using a master gauge first.