Home › Engine / Hybrid System › 3ZR-FAE INTAKE / EXHAUST › INTAKE MANIFOLD › 2012.12–2015.04
RM3090E _51 Engine / Hybrid System _008390 3ZR-FAE INTAKE / EXHAUST _0046831 INTAKE MANIFOLD A

3ZR-FAE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 12635 1.INSTALL ENGINE COVER JOINT

a.

Install the engine cover joint.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 23265 2.INSTALL NO. 1 GAS FILTER

a.

Using a 24 mm deep socket wrench, install the No. 1 gas filter to the intake manifold.

Torque:
17 N*m (173 kgf*cm, 13 ft.*lbf)


b.

Install the No. 1 air hose to the intake manifold and No. 1 gas filter.


Hide 17111 3.INSTALL INTAKE MANIFOLD

a.

with Stud Bolt:

Using an E6 "TORX" socket wrench, install the 2 stud bolts to the intake manifold.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Install the wire harness clamp bracket to the intake manifold with the bolt.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


c.

Install a new gasket to the intake manifold.


d.

Temporarily install the intake manifold stay and intake manifold with the 5 bolts and 2 nuts.


e.

After temporarily installing the 5 bolts and 2 nuts, tighten them to the specified torque in several steps.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


f.

Connect the PCV hose to the intake manifold, and slide the clamp to secure it.


g.

Connect the fuel vapor feed hose to the intake manifold.


h.

Attach the 4 clamps to the intake manifold.


i.

Install the wire harness clamp bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 25860 4.INSTALL VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

a.

Install the vacuum switching valve assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the No. 2 air hose and vacuum hose.


c.

Connect the vacuum switching valve assembly connector.


Hide 5.INSTALL VACUUM SENSOR ASSEMBLY

a.

Connect the No. 1 air hose to the vacuum sensor assembly.


b.

Install the vacuum sensor assembly with the engine cover joint.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect the vacuum sensor assembly connector.


Hide 22210 6.INSTALL THROTTLE BODY ASSEMBLY

Hide 28100 7.INSTALL STARTER ASSEMBLY