Home › Engine / Hybrid System › 3ZR-FAE COOLING › THERMOSTAT
RM3090E _51 Engine / Hybrid System _008391 3ZR-FAE COOLING _0046839 THERMOSTAT A

3ZR-FAE COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16331A 1.INSTALL THERMOSTAT

a.

Install a new gasket to the thermostat.


b.
A156459C02
2.615,0.448 2.469,0.448 2.469,0.448 1.573,1.021 true 1.188,0.052 1.49,0.219 0.302,0.167 10 10° 1.677,0.052 1.979,0.219 0.302,0.167 10 10° 2.656,0.375 2.969,0.531 0.313,0.156 10 *1
*1 Jiggle Valve


Install the thermostat to the water inlet.

NOTICE:

The jiggle valve must be set within 10° on either side of the position shown in the illustration.



Hide 16321 2.CONNECT WATER INLET

a.

Connect the water inlet with the 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 51441 6.INSTALL NO. 1 ENGINE UNDER COVER