Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0046855 CAMSHAFT OIL CONTROL VALVE G

3ZR-FAE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.



b.
A160184
2.5,0.115 2.573,0.115 2.573,0.115 2.708,0.479 true 3.042,0.115 2.979,0.115 2.979,0.115 2.854,0.479 true 2.365,0.031 2.49,0.198 0.125,0.167 10 1 3.083,0.031 3.208,0.198 0.125,0.167 10 2 0.052,0.052 0.208,0.229 0.156,0.177 10 *a
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)


Check the operation.

i.

Connect the battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.

OK:
Measurement Condition Specified Condition
Battery positive (+) voltage is applied Valve moves in left arrow direction shown in illustration
Battery positive (+) voltage is cut off Valve moves in right arrow direction shown in illustration


NOTICE:

Confirm that the valve moves freely and does not stick in any position.


If the result is not as specified, replace the camshaft timing oil control valve assembly.

HINT:

Accumulation of foreign matter causes subtle pressure leaks. The subtle pressure leaks will cause the camshaft to advance, and this will cause a DTC to be stored.