Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › CONTINUOUSLY VARIABLE VALVE LIFT CONTROLLER
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0046856 CONTINUOUSLY VARIABLE VALVE LIFT CONTROLLER G

3ZR-FAE ENGINE CONTROL  CONTINUOUSLY VARIABLE VALVE LIFT CONTROLLER  INSPECTION  


PROCEDURE

Hide 222A0 1.INSPECT CONTINUOUSLY VARIABLE VALVE LIFT CONTROLLER ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VALVEMATIC (ENG OFF).

Powertrain > Engine and ECT > Active Test
Tester Display
Activate the VALVEMATIC(ENG OFF)
50004 234 164
NOTICE:
·

Make sure to perform the "Activate the VALVEMATIC (ENG OFF)" Active Test with the continuously variable valve lift controller assembly removed from the vehicle.

·

Perform the Active Test with the body of the continuously variable valve lift controller assembly connected to ground, as the continuously variable valve lift controller assembly is grounded through the body.

OK
Tester Operation Specified Condition
Low VALVEMATIC Current Angle is 100 to 120°CA and shaft extends
High VALVEMATIC Current Angle is 250°CA or more and shaft retracts