Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › THROTTLE BODY
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0046857 THROTTLE BODY A

3ZR-FAE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 11212 3.REMOVE NO. 2 CYLINDER HEAD COVER

a.
A293338

Hold the rear of the No. 2 cylinder head cover and raise it to detach the 2 clips on the rear of the No. 2 cylinder head cover. Continue to raise the No. 2 cylinder head cover to detach the 2 clips on the front of the No. 2 cylinder head cover and remove the No. 2 cylinder head cover.

NOTICE:

Attempting to detach both front and rear clips at the same time may cause the No. 2 cylinder head cover to break.



Hide 17705 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A293339

Disconnect the mass air flow meter connector.


b.

Detach the wire harness from the air cleaner cap sub-assembly.


c.
A293340

Disconnect the 2 clamps.


d.
A293341

Slide the clamp and disconnect the PCV hose from the cylinder head cover sub-assembly.


e.

Lock the air cleaner cap sub-assembly hose clamp, and then remove the air cleaner cap sub-assembly.


Hide 22210 5.REMOVE THROTTLE BODY ASSEMBLY

a.
A209054

Disconnect the throttle body assembly connector.


b.

Slide the 2 clamps and disconnect the water by-pass hose and No. 2 water by-pass hose.


c.
A209055

for Type A:

Remove the 2 bolts, 2 nuts and throttle body assembly.


d.

for Type B:

Remove the 4 bolts and throttle body assembly.


e.

Remove the gasket from the intake manifold.