Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › MASS AIR FLOW METER
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0046860 MASS AIR FLOW METER G

3ZR-FAE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A208126
0.823,0.313 0.521,0.313 0.521,0.313 0.74,1.313 true 0.854,0.25 1.031,0.396 0.177,0.146 10 *1
*1 Platinum Hot Wire (Heater)


Visually check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter sub-assembly shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter sub-assembly.


b.
A127786
2.927,1.448 2.927,0.729 2.927,0.729 3,0.729 false 2.781,1.458 2.583,0.729 2.583,0.729 2.448,0.729 false 2.177,0.646 2.417,0.813 0.24,0.167 10 E2 3.031,0.646 3.365,0.802 0.333,0.156 10 THA 0.063,0.052 0.229,0.219 0.167,0.167 10 *a
*a Component without harness connected
(Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
1 (THA) - 2 (E2) 20°C (68°F) 2.21 to 2.69 kΩ
1 (THA) - 2 (E2) 60°C (140°F) 0.493 to 0.667 kΩ


If the result is not as specified, replace the mass air flow meter sub-assembly.