Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0046866 MANIFOLD ABSOLUTE PRESSURE SENSOR G

3ZR-FAE ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK VACUUM SENSOR ASSEMBLY

a.
A124891
2.635,1.635 2.521,1.635 2.521,1.635 2.094,1.229 true 0.792,1.635 0.948,1.635 0.948,1.635 1.344,1.24 true 0.552,1.563 0.792,1.74 0.24,0.177 10 E2 2.677,1.552 2.938,1.729 0.26,0.177 10 VC 0.063,0.073 0.24,0.271 0.177,0.198 10 *a
*a Front view of wire harness connector
(to Vacuum Sensor Assembly)


Inspect the power source voltage.

i.

Disconnect the vacuum sensor assembly connector.


ii.

Turn the ignition switch to ON.


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
3 (VC) - 1 (E2) Ignition switch ON 4.75 to 5.25 V



iv.

Turn the ignition switch off.


v.

Reconnect the vacuum sensor assembly connector.



b.

Check the vacuum and pressure.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON and turn the GTS on.


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

Powertrain > Engine and ECT > Data List
Tester Display
MAP
50003 234 4

iv.

Read the MAP value.

OK:
Condition Specified Condition
No pressure applied Same as atmospheric pressure
Vacuum applied Indicates vacuum
Pressure applied Indicates pressure


If the result is not as specified, replace the vacuum sensor assembly.