83320
1.INSPECT FUEL SENDER GAUGE ASSEMBLY
Check that the float moves smoothly between F and E.
| *a | Component without harness connected
(Fuel Sender Gauge Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Float position is F
(upper) |
13.5 to 16.5 Ω |
| Float position is 1/2 | 200.2 to 224.8 Ω | |
| Float position is E
(lower) |
405.5 to 414.5 Ω |
If the value is not as specified, replace the fuel sender gauge assembly.