Home › Engine / Hybrid System › 2AR-FE INTAKE / EXHAUST › INTAKE AIR CONTROL VALVE ACTUATOR(for TCV)
RM3090E _51 Engine / Hybrid System _008399 2AR-FE INTAKE / EXHAUST _0046896 INTAKE AIR CONTROL VALVE ACTUATOR(for TCV) A

2AR-FE INTAKE / EXHAUST  INTAKE AIR CONTROL VALVE ACTUATOR(for TCV)  INSTALLATION  


PROCEDURE

Hide 17335 1.INSTALL INTAKE AIR CONTROL VALVE ACTUATOR

NOTICE:
·
A203084

Make sure that foreign matter, such as water, oil, sand and iron particles, does not enter the gear chamber or actuator at the locations marked by the circles in the illustration.

·
A197294

Do not loosen or remove the bolt and 2 nuts shown in the illustration.



a.
A293722C01
0.052,0.052 0.25,0.229 0.198,0.177 10 *a
*a Condition: Closed


Close the tumble control valves.

HINT:

If the tumble control valves are not closed, close them by hand.



b.
A196060

Check that the gear of the tumble control valve is in the position shown in the illustration.

HINT:

Turn the gear clockwise until it contacts the stopper.



c.

Install a new gasket to the intake air control valve actuator.


d.

Install the intake air control valve actuator to the intake manifold with the 2 bolts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)

NOTICE:
·

If excessive force is applied to the gear in the direction of rotation when installing the actuator, the valves and actuator may be damaged.

·

After installing the actuator, make sure the ends of the valves are not protruding from the surface where the intake manifold is installed. If the valves are protruding, remove and reinstall the actuator.