Home › Engine / Hybrid System › 2AR-FE INTAKE / EXHAUST › VACUUM SWITCHING VALVE(for ACIS)
RM3090E _51 Engine / Hybrid System _008399 2AR-FE INTAKE / EXHAUST _0046899 VACUUM SWITCHING VALVE(for ACIS) G

2AR-FE INTAKE / EXHAUST  VACUUM SWITCHING VALVE(for ACIS)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17650 1.INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 37 to 44 Ω
1 - Body ground Always 1 MΩ or higher
2 - Body ground


If the result is not as specified, replace the vacuum switching valve assembly.


b.

Check the vacuum switching valve operation.

i.
A201321
2.083,3.375 2.083,3.844 false 1,3.208 1.521,2.417 1.521,2.417 1.646,2.417 false 1.688,2.323 1.854,2.51 0.167,0.188 10 *1 2,3.865 2.177,4.052 0.177,0.188 10 *2
*1 Port E
*2 Filter
V100135

Air


When vacuum is applied to port E, check that air is sucked into the filter.

If the result is not as specified, replace the vacuum switching valve assembly.


ii.
A201322
0.385,4.167 0.385,3.75 true 1.823,4.167 1.49,4.167 1.49,4.167 0.563,3.438 true 0.292,4.188 0.469,4.354 0.177,0.167 10 *1 1.865,4.094 2.042,4.271 0.177,0.177 10 *2
*1 Port F
*2 Port E
V100135

Air


Apply battery voltage across the terminals. When vacuum is applied to port F, check that air is sucked into port E.

If the result is not as specified, replace the vacuum switching valve assembly.