Home › Engine / Hybrid System › 2AR-FE STARTING › STARTER(for 1.6 kW Type)
RM3090E _51 Engine / Hybrid System _008402 2AR-FE STARTING _0046913 STARTER(for 1.6 kW Type) A

2AR-FE STARTING  STARTER(for 1.6 kW Type)  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A194756

Remove the nut and disconnect the lead wire from terminal C.


b.
A194757

Remove the 2 nuts holding the magnet starter switch assembly to the starter drive housing assembly.


c.

Remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A194758

Remove the 2 through-bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.


b.
A194759

Remove the starter yoke assembly from the starter commutator end frame assembly.


Hide 28177 3.REMOVE STARTER ARMATURE PLATE

a.
A194760

Remove the starter armature plate from the starter yoke assembly.


Hide 28132A 4.REMOVE STARTER COMMUTATOR END FRAME COVER

a.
A194761

Using a screwdriver, pry out the starter commutator end frame cover to remove it.


Hide 28160 5.REMOVE STARTER ARMATURE ASSEMBLY

a.
A194762
1.16,0.189 1.354,0.374 0.194,0.185 10 *1 1.744,0.482 1.463,0.288 1.463,0.288 1.398,0.288 false
*1 Snap Ring Pliers


Using snap ring pliers, remove the snap ring and washer.


b.

Remove the starter armature assembly from the starter commutator end frame assembly.

NOTICE:

Do not drop the starter armature assembly.



Hide 28117A 6.REMOVE RUBBER SEAL

a.
A194763

Remove the rubber seal from the repair service starter kit.


Hide 28255 7.REMOVE PLANETARY GEAR

a.
A194764

Remove the 3 planetary gears from the repair service starter kit.