Home › Power Source / Network › 2AR-FE BATTERY / CHARGING › GENERATOR(for 100 A Type)
RM3090E _57 Power Source / Network _008403 2AR-FE BATTERY / CHARGING _0046918 GENERATOR G

2AR-FE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27415 1.INSPECT GENERATOR PULLEY WITH CLUTCH

a.
A192786C02
1.198,0.688 1.188,0.698 false
V100135

Free
V100136

Lock


Hold the center of the generator pulley with clutch and confirm that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the generator pulley with clutch.


Hide 27370 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A128079C15
0.635,0.708 0.948,0.865 0.313,0.156 10 *1
*1 Length


Using a vernier caliper, measure the brush length.

Standard length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum length:

4.5 mm (0.177 in.)


If the brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 3.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A298994C01
1.708,0.896 2.125,0.365 2.125,0.365 2.365,0.365 false 1.854,0.948 2.135,0.365 false 2.427,0.292 2.74,0.448 0.313,0.156 10 *1
*1 Slip Ring


Check the rotor for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.8 to 2.2 Ω


If the result is not as specified, replace the generator rotor assembly.



b.
A298995C01
1.875,0.958 2.104,0.458 2.104,0.458 2.323,0.458 false 0.25,1.135 0.406,1.135 0.406,1.135 0.823,0.688 true 2.365,0.375 2.677,0.531 0.313,0.156 10 *1 0.073,1.052 0.385,1.208 0.313,0.156 10 *2
*1 Slip Ring
*2 Rotor Core


Check if the rotor is grounded.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



c.

Check the slip ring diameter.

i.
A124106C04
0.667,0.531 0.979,0.688 0.313,0.156 10 *1
*1 Diameter


Using a vernier caliper, measure the diameter of each slip ring.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.



d.

Check the bearing.

i.
A158899

Check that the bearing is not rough or worn and that it rotates smoothly.

If the result is not as specified, replace the generator rotor assembly.