11101J
1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 6.9 to 7.9 Ω |
If the result is not as specified, replace the camshaft timing oil control valve assembly.
| *a | Component without harness connected
(Camshaft Timing Oil Control Valve Assembly) |
Connect the battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2 and check the movement of the valve.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) voltage is applied | Valve moves in left arrow direction shown in illustration |
| Battery positive (+) voltage is cut off | Valve moves in right arrow direction shown in illustration |
If the result is not as specified, replace the camshaft timing oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be stored.