Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › THROTTLE BODY
RM3090E _51 Engine / Hybrid System _008378 2AR-FE ENGINE CONTROL _0046921 THROTTLE BODY G

2AR-FE ENGINE CONTROL  THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY

A241618
1.927,1.646 1.927,1.542 1.927,1.542 2.083,1.25 false 2.604,1.646 2.604,1.542 2.604,1.542 2.302,1.25 false 2.479,1.667 2.677,1.823 0.198,0.156 10 M- 1.802,1.667 2.031,1.823 0.229,0.156 10 M+ 0.042,0.052 0.188,0.229 0.146,0.177 10 *a
*a Component without harness connected
(Throttle with Motor Body Assembly)


a.

Check that the throttle valve opens and closes smoothly.


b.

Check that the there is no sludge accumulating around the throttle body.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω


If the result is not as specified, replace the throttle with motor body assembly.