Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM3090E _51 Engine / Hybrid System _008378 2AR-FE ENGINE CONTROL _0046924 MASS AIR FLOW METER G

2AR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter sub-assembly inspection according to the procedures below.

·

Only replace the mass air flow meter sub-assembly when the mass air flow value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON (do not run the engine).


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

e.

Wait 30 seconds, and then read the values on the GTS.

Standard:
Item Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after turning ignition switch to ON


0.51g/sec. or less


If the result is not as specified, replace the mass air flow meter sub-assembly.

If the result is as specified, inspect the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION