Perform "Inspection After Repairs" after replacing the knock sensor.
w/ Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
89615
1.INSTALL KNOCK SENSOR
| *a | Top |
| *b | Front of Engine |
Install the knock sensor with the bolt so that the knock sensor is angled as shown in the illustration.
The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.
Perform "Inspection After Repairs" after replacing the knock sensor.
w/ Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/o Canister Pump Module)>INITIALIZATION
Connect the knock sensor connector.
17111
2.INSTALL INTAKE MANIFOLD