Home › Engine / Hybrid System › 2AD-FHV ENGINE MECHANICAL › DRIVE BELT
RM3090E _51 Engine / Hybrid System _008404 2AD-FHV ENGINE MECHANICAL _0046937 DRIVE BELT A

2AD-FHV ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.
A214114N01
0.643,2.576 0.952,2.764 0.309,0.188 10 SST 1.941,2.235 1.117,2.654 1.117,2.654 1.005,2.654 false

Using SST and a 22 mm wrench, rotate the V-ribbed belt tensioner assembly pulley counterclockwise, and then install the fan and generator V belt.

SST
09216-42010  

CAUTION:
·

Be careful as the wrench only fits loosely on the V-ribbed belt tensioner assembly tool set point. The wrench may come off the set point and cause injuries.

·

Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.



NOTICE:
·

Make sure that the fan and generator V belt is set properly on each pulley.

·

Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.




Hide 51217A 2.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

a.
A295895

Install the front suspension member reinforcement RH with the 4 bolts.

Torque:
99 N*m (1010 kgf*cm, 73 ft.*lbf)


Hide 51443 3.INSTALL REAR ENGINE UNDER COVER RH

a.

Install the rear engine under cover RH with the 2 clips.


Hide 51441 4.INSTALL NO. 1 ENGINE UNDER COVER