Home › Engine / Hybrid System › 2AD-FHV ENGINE MECHANICAL › DRIVE BELT
RM3090E _51 Engine / Hybrid System _008404 2AD-FHV ENGINE MECHANICAL _0046937 DRIVE BELT G

2AD-FHV ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FAN AND GENERATOR V BELT

a.
A205800

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
A205801
0.656,1.25 0.969,1.406 0.313,0.156 10 *a 2.719,1.271 3.031,1.427 0.313,0.156 10 *b 1.802,1.271 2.115,1.427 0.313,0.156 10 *b
*a CORRECT
*b INCORRECT


Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



Hide 16620 2.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY

a.
A132215

Check that nothing gets caught in the V-ribbed belt tensioner assembly by turning it clockwise and counterclockwise.

If a malfunction exists, replace the V-ribbed belt tensioner assembly.