Home › Engine / Hybrid System › 2AD-FHV ENGINE MECHANICAL › CYLINDER HEAD
RM3090E _51 Engine / Hybrid System _008404 2AD-FHV ENGINE MECHANICAL _0046939 CYLINDER HEAD A

2AD-FHV ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Take off the cutter gradually to make the valve seat smooth.



a.
A110502
2.51,0.323 2.802,0.521 0.292,0.198 10 false 45° 3.135,0.615 3.406,0.813 0.271,0.198 10 false 30° 3,1.74 3.313,1.896 0.313,0.156 10 false *a
*a Width
*b 45°
*c 30°


If the seating is too high on the intake valve face, use 30° and 45° cutters to correct the seat.


b.
A101380
2.375,0.427 2.667,0.625 0.292,0.198 10 false 60° 3.021,0.677 3.302,0.875 0.281,0.198 10 false 45° 2.979,1.906 3.292,2.063 0.313,0.156 10 false *a
*a Width
*b 60°
*c 45°


If the seating is too low on the intake valve face, use 60° and 45° cutters to correct the seat.


c.

Check that the seat contact is in the middle of the intake valve face and has the following width.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



Hide 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Take off the cutter gradually to make the valve seat smooth.



a.
A110503
2.5,0.333 2.771,0.5 0.271,0.167 10 false 45° 3.125,0.604 3.396,0.771 0.271,0.167 10 false 30° 2.969,1.75 3.281,1.906 0.313,0.156 10 false *a
*a Width
*b 45°
*c 30°


If the seating is too high on the exhaust valve face, use 30° and 45° cutters to correct the exhaust valve seat.


b.
A101382
2.302,0.406 2.552,0.573 0.25,0.167 10 false 60° 3.094,0.573 3.375,0.74 0.281,0.167 10 false 45° 3.042,1.854 3.354,2.01 0.313,0.156 10 false *a
*a Width
*b 60°
*c 45°


If the seating is too low on the exhaust valve face, use 60° and 45° cutters to correct the exhaust valve seat.


c.

Check that the seat contact is in the middle of the exhaust valve face and has the following width.

Standard width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)