Home › Engine / Hybrid System › 3ZR-FE EMISSION CONTROL › PURGE VALVE
RM3090E _51 Engine / Hybrid System _008407 3ZR-FE EMISSION CONTROL _0046961 PURGE VALVE G

3ZR-FE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VSV

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω
1 - VSV body Always 10 MΩ or higher
2 - VSV body Always 10 MΩ or higher



b.

Check the operation of the purge VSV.

i.
A211314
0.927,1.406 1.156,1.406 1.156,1.406 1.354,1.698 true 0.958,0.938 1.219,0.938 1.219,0.938 1.625,1.365 true 0.813,0.865 0.958,1.042 0.146,0.177 10 E 0.802,1.333 0.917,1.521 0.115,0.188 10 F 1.01,1.708 1.198,1.885 0.188,0.177 10 *a
*a Does not flow


Check that air does not flow from port E to port F.


ii.
A211315
1.542,1.188 1.833,1.458 1.833,1.458 2.063,1.458 true 1.469,1.177 1.667,1.802 1.667,1.802 1.865,1.802 true 2.104,1.375 2.219,1.542 0.115,0.167 10 1 1.906,1.719 2.01,1.875 0.104,0.156 10 2
V100135

Air


Apply battery voltage to terminals 1 and 2.


iii.

Check that air flows from port E to port F.

If the result is not as specified, replace the purge VSV.