Home › Engine / Hybrid System › 3ZR-FE INTAKE / EXHAUST › INTAKE MANIFOLD
RM3090E _51 Engine / Hybrid System _008408 3ZR-FE INTAKE / EXHAUST _0046965 INTAKE MANIFOLD A

3ZR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 12635 1.INSTALL ENGINE COVER JOINT

a.

Install the engine cover joint.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 17111 2.INSTALL INTAKE MANIFOLD

a.

with Stud Bolt:

Using an E6 "TORX" socket wrench, install the 2 stud bolts to the intake manifold.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Install the wire harness clamp bracket to the intake manifold with the bolt.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


c.

Install a new gasket to the intake manifold.


d.

Temporarily install the intake manifold stay and intake manifold with the 5 bolts and 2 nuts.


e.

After temporarily installing the 5 bolts and 2 nuts, tighten them to the specified torque in several steps.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)


f.

Connect the fuel vapor feed hose and No. 3 air hose to the intake manifold.


g.

Connect the PCV hose and No. 1 vacuum transmitting hose to the intake manifold, and 2 slide the clamps to secure it.


h.

Attach the 4 wire harness clamps.


Hide 17650G 3.INSTALL VACUUM SWITCHING VALVE (for ACIS)

a.

Install the vacuum switching valve with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the vacuum hose and No. 2 air hose.


c.

Connect the vacuum switching valve connector.


d.

Attach the wire harness clamp.


e.

Install the wire harness clamp bracket with the engine cover joint.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 22210 4.INSTALL THROTTLE BODY ASSEMBLY