Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › THROTTLE BODY
RM3090E _51 Engine / Hybrid System _008380 3ZR-FE ENGINE CONTROL _0046990 THROTTLE BODY G

3ZR-FE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22210 1.CHECK THROTTLE BODY ASSEMBLY

a.

Check for throttle control motor operating sounds.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check for operating sounds of the motor. Make sure that no friction noise is emitted from the motor.

If any friction noise exists, replace the throttle body.



b.

Check the throttle position sensor.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON and turn the GTS on.


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position.

Powertrain > Engine and ECT > Data List
Tester Display
Throttle Sensor Position
50003 234 12

iv.

Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of "Throttle Sensor Position" is within the specification.

Standard throttle valve opening percentage:

60% or more


HINT:

When checking the standard throttle valve opening percentage, the shift lever should be in neutral (for Manual Transaxle) or N (for CVT).


If the percentage is less than 60%, replace the throttle body assembly.