78110K
1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
| Tester Display |
|---|
| Accel Sensor Out No.1 |
| Accel Sensor Out No.2 |
Read the value displayed on the GTS.
| Accelerator Pedal Operation | Accel Sensor Out No. 1 | Accel Sensor Out No. 2 |
|---|---|---|
| Released | 0.5 to 1.1 V | 1.2 to 2.0 V |
| Depressed | 2.6 to 4.5 V | 3.4 to 5.0 V |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.