Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM3090E _51 Engine / Hybrid System _008380 3ZR-FE ENGINE CONTROL _0046993 MASS AIR FLOW METER G

3ZR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the mass air flow value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.CHECK MASS AIR FLOW METER SUB-ASSEMBLY

a.

Read the value using the GTS (mass air flow).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON (do not run the engine).


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

iv.

Wait 30 seconds, and then read the values on the GTS.

Standard:
Tester Display Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after ignition switch turned to ON


0.31g/sec. or less


If the result is not as specified, replace the mass air flow meter sub-assembly.

If the result is within the specified range, inspect the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION