Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008380 3ZR-FE ENGINE CONTROL _0046999 AIR FUEL RATIO SENSOR A

3ZR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A293733C02
0.719,1.635 0.917,1.635 0.917,1.635 1.344,1.26 true 2.375,1.417 2.573,1.594 0.198,0.177 10 *1 0.385,1.563 0.729,1.74 0.344,0.177 10 SST
*1 Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Make sure SST and the wrench are connected in a straight line.

·

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



NOTICE:

Do not damage the air fuel ratio sensor.



b.

Connect the air fuel ratio sensor connector and clamp.