Home › Engine / Hybrid System › 3ZR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR
RM3090E _51 Engine / Hybrid System _008380 3ZR-FE ENGINE CONTROL _0047000 HEATED OXYGEN SENSOR G

3ZR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

a.
A210693
1.958,1.073 2.323,0.708 2.323,0.708 2.531,0.708 true 0.906,0.75 1.146,0.75 1.146,0.75 1.51,1.094 true 0.865,1.677 1.177,1.677 1.177,1.677 1.51,1.365 true 0.073,0.094 0.26,0.281 0.188,0.188 10 *a 0.667,0.677 0.948,0.896 0.281,0.219 10 +B 0.656,1.604 0.958,1.813 0.302,0.208 10 E2 2.573,0.635 3.135,0.885 0.563,0.25 10 HT1B
*a Component without harness connected
(Heated Oxygen Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (HT1B) - 1 (+B) 20°C (68°F) 11 to 16 Ω
2 (HT1B) - 3 (E2) Always 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.