Home › Engine / Hybrid System › 1AD-FTV FUEL › FUEL SUPPLY PUMP › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008413 1AD-FTV FUEL _0047005 FUEL SUPPLY PUMP G

1AD-FTV FUEL  FUEL SUPPLY PUMP  INSPECTION  


PROCEDURE

Hide 22100 1.INSPECT FUEL SUPPLY PUMP ASSEMBLY

a.

Inspect the suction control valve assembly.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 1.9 to 2.3 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the suction control valve.


If the result is not as specified, replace the suction control valve assembly.



b.

Inspect the fuel temperature sensor.

Click hereEngine / Hybrid System>1AD-FTV FUEL>FUEL TEMPERATURE SENSOR>INSPECTION

If the result is not as specified, replace the fuel temperature sensor.