Home › Engine / Hybrid System › 1AD-FTV FUEL › FUEL INJECTOR › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008413 1AD-FTV FUEL _0047012 FUEL INJECTOR G

1AD-FTV FUEL  FUEL INJECTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 23670 1.CHECK INJECTOR ASSEMBLY

a.

Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.


b.

Allow the engine to idle for 1 minute or more.


c.

Connect the GTS to the DLC3.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Data List / Injection Volume and Injector Feedback Val. #1 to #4.

Powertrain > Engine > Data List
Tester Display
Injection Volume
Injection Feedback Val #1
Injection Feedback Val #2
Injection Feedback Val #3
Injection Feedback Val #4
50003 61 376,368,369,370,371

f.

Read the values when the engine is idling.


g.

Check that the "Injector Feedback Val. #1 to #4" values are within the specification.

Standard:
Tester Display Engine Condition Specified Condition
Injection Volume Idling 3 to 10 mm3/st
Injector Feedback Val. #1
Injector Feedback Val. #2
Injector Feedback Val. #3
Injector Feedback Val. #4
Idling -3.0 to 3.0 mm3/st


If the result is not as specified, replace the injector assembly.