Home › Drivetrain › U660F AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM3090E _52 Drivetrain _008436 U660F AUTOMATIC TRANSMISSION / TRANSAXLE _0047080 AUTOMATIC TRANSAXLE SYSTEM D

U660F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  CHECK MODE PROCEDURE  


DESCRIPTION


a.

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are stored with 1-trip detection logic.



CHECK MODE PROCEDURE


a.

Make sure that the following conditions are met:

i.

Battery positive voltage is 11 V or higher.


ii.

Throttle valve is fully closed.


iii.

Shift lever is in P or N.


iv.

A/C is off.



b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / ECT / Utility / Check Mode.

Powertrain > ECT > Utility
Tester Display
Check Mode
50005 64 1

g.
C140840E01
0.272,0.643 0.539,0.844 0.267,0.201 10 ON 0.272,1.437 0.623,1.638 0.350,0.201 10 OFF 2.017,0.368 3.025,0.569 1.008,0.201 10 0.13 seconds 1.91,1.709 2.806,1.910 0.897,0.201 10 0.13 seconds

Change the TCM to check mode. Make sure the MIL flashes as shown in the illustration.

NOTICE:

All DTCs and freeze frame data will be cleared if: 1) the GTS is used to change the TCM from normal mode to check mode or vice versa; or 2) during check mode, the ignition switch is turned from ON to ACC or off.

Before entering check mode, make a note of the DTCs and freeze frame data.



h.

Start the engine. The MIL should turn off after the engine starts.


i.

Perform "Monitor Drive Pattern" for the ECT test, or simulate the conditions of the malfunction described by the customer.

Click hereDrivetrain>U660F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>MONITOR DRIVE PATTERN


j.

After simulating the malfunction conditions, use the GTS to check the DTCs and freeze frame data.