The TCM memory contains the programs for the normal and sport shift patterns.
By following the programs corresponding to the signals from the combination switch assembly, park/neutral position switch and other various sensors, the TCM switches the shift solenoid valves on and off, and controls the transaxle gear ratio.
Refer to the inspection procedure for the CAN communication system.
If the CAN communication malfunctions, the TCM cannot receive current data from the ECM. In this case, the freeze frame data output from the TCM has not been updated, so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is an effective way to find malfunctions.
The malfunctioning area can be confirmed using the Bus Check function of the GTS.
for LHD:
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM
for RHD:
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM
| *1 | Combination Switch Assembly |
Remove the combination switch assembly.
Click hereDrivetrain>U660F AUTOMATIC TRANSMISSION / TRANSAXLE>COMBINATION SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (MSW1) - 4 (MSW2) | Combination switch (SPORT) on | Below 1 Ω |
| 2 (MSW1) - 4 (MSW2) | Combination switch (SPORT) off | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Combination Switch Assembly) |
Disconnect the combination switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G60-4 (MSW2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to ECM) |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A61-36 (PWMS) - Body ground | Combination switch (SPORT) on | Below 1 Ω |
| A61-36 (PWMS) - Body ground | Combination switch (SPORT) off | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG